#Dsc panic button programming how to#
#Dsc panic button programming portable#

(2) Choose a WT4989 Programmable Option from the To program WT4989 Options: (1) Press and hold all 4 buttons at the same time until the For UL Listed installations, refer to the control panel'sĬhanging the programming will affect operation. Other WT4989 options are available in order to program the best possible combination to suit specific needs. Mode** Press all at the same time to proNumber** Press both at the same gram optional button functions. Press both at the same time to acti- both at the same time to activate the To unlock the keys,Īway Arming: Press to arm your sysStay Arming: Press to armĭisarm: Press to disarm your central monitoring station of a situation Enter the 8-digit ESN located on the Key 2Īngle icon ( ) flashes briefly before the keyfob turns off. Repeat from step 2 to enroll additional remotes.ġ. The Keypad will display the 8-digit ESN, confirm by pressing. Press any key on the wireless device to activate it. Section, enter through installer programming. The table below summarizes the possible main system statuses that can be shown Receivers, please refer to the specific receiver Installation Manual. The following outlines the basic steps for programming andĮnrolling this device on PowerSeries receivers.

#Dsc panic button programming how to#

This section describes how to set up and program your remote, this should beĭone by the installer.

These actions also confirm that a signal has been sent to the control panel receiver. Icon turn on and the buzzer beeps once, indicating that a button has been pressed. Note that some keyįunctions require a 3 second** press. To activate, press and hold a button for approximately 1 second*.

#Dsc panic button programming portable#

Together with your installer, you canĭecide which functions you wish to have accessible from your portable key. With the convenience of wireless portability. (i.e., 9155 security systems) to allow you toĪrm, disarm and confirm your requested actions, as well as other keypad functions The wireless key communicates with compatible wireless receivers That the wireless key has sent a command to To audibly indicate a button was pressed, or Icons that come on to show the system status when the Status Request button is The WT4989 is a five-button two-way wireLCD ICONSīuilt-in buzzer. IMPORTANT: This equipment shall be used in an environment that provides